Procedure of assembly wiring
To each page : 1 , 2 , 3 , 4 , 5 , 6 , 7 , 8 , 9 , 10 , 11 , 12 , 13

Mount the resisitor R3

Mount the resistor R3 to 8C and 12C.
Bend the lead of 8C toward 8B a little.
Bend the lead of 12C to 12D, and bend more to 12E, 12F, 12G and 12H. And cut it at 12H.
Hold down R3 from the parts side, and adjust the angle of the lead of R3 of 8C side, and put the lead of 12C side lead of R3 to 12H.
Solder the lead 12C of R3.
The wire from 12C to 12H is long. Then it needs to hold down to the printed board.
As 12C is soldered, at the 12C the lead lift up little, and straight it, and hold down again to the printed board.
Solder the lead of C6 and R3 at 12H together.
Bend the lead 8C to 8D, and bend more to 8E, and cut it at 8E.
Solder the lead of R3 at 8C.
Solder at 12D, 12E, 12F, 12G and 8D to the turn.

Mount the resisitor R5

Mount the resistor R5 to 8M and 12M.
Bend the lead of 8M toward 7M a little.
Bend the lead of 12M to 13N, and bend more to 14N and 15N. And cut it at 15N.
Hold down R5 from the parts side, and adjust the angle of the lead of R5 of 8M side, and put the lead of 12M side lead of R5 to 15N.
Solder the lead of R5 and D1 at the 15N together.
Solder the lead of R5 at 12M.
Bend the lead 8M to 8L, and bend more to 8K, and cut it at 8K.
Solder the lead of R5 at 8M.
Solder at 13N and 14N to the turn.