[Menu]>[Guide to use the PIC]>[877 Hardware]

Configuration Bits of PIC16F877

PIC16F877 has the special area to say Configuration Word in the program memory. This word is mapped in program memory location 2007h. This address is beyond the user program memory space. This word can be accessed only during programming. The following system requirements of PIC can be designated by the configuration word. CP1,CP0 : Flash Program Memory Code Protection Bits. All of the CP1:CP0 pairs have to be given the same value to enable the code protection scheme listed. 11 : Code protection off 10 : 1F00h to 1FFFh code protected 01 : 1000h to 1FFFh code protected 00 : 0000h to 1FFFh code protected DEBUG : In-Circuit Debugger Mode 1 : In-Circuit Debugger disabled, RB6 and RB7 are general purpose I/O pins. 0 : In-Circuit Debugger enabled, RB6 and RB7 are dedicated to the debugger. WRT : Flash Program Memory Write Enable 1 : Unprotected program memory may be written to by EECON control 0 : Unprotected program memory may not be written to by EECON control CPD : Data EEPROM memory Code Protection 1 : Code protection off 0 : Data EEPROM memory code protected LVP : Low Voltage In-Circuit Serial Programming Enable bit 1 : RB3/PGM pin has PGM function, low voltage programming enabled The high voltage programming mode is always available, regardless of the state of the LVP bit. 0 : RB3 is digital I/O, High Voltage on MCLR must be used for programming BODEN : Brown-out Reset Enable bit 1 : BOR enabled 0 : BOR disabled PWRTE : Power-up Timer Enable bit 1 : PWRT disabled 0 : PWRT enabled WDTE : Watchdog Timer Enable bit 1 : WDT enabled 0 : WDT disabled FOSC1,FOSC0 : Oscillator Selection bits 11 : RC : Resistor/Capacitor oscillator ( Less than 1MHz ) 10 : HS : High Speed Crystal/Resonator oscillator ( 4MHz to 20MHz ) 01 : XT : Crystal/Resonator oscillator ( Less than 4MHz ) 00 : LP : Low Power Crystal oscillator ( Less than 200KHz )