[
Menu
]>[
Circuits Gallery
]>[
Room temperature controller
]>[
Making process
]
Making process of Temperature sensor
From right side, Temperature sensor(LM35DZ), Case(cover of a mini jack), Shielded cable and Insulated tube(2mm).
The lead of a sensor is cut short and a cable is soldered to it. From left side, Grounding, Sensor output and Power.
In order to prevent a short circuit, a tube is put on the lead of a sensor.
Finally a vinyl tape is twisted. This purpose is fixing the insulated tubes and adjusting thickness so that a sensor may not escape from the case.
The sensor is set inside for a while from the end of a case.
This is the picture of a temperature sensor cable.
