When making the case with the plastic board, it cuts the board in the necessary size. In this page, I introduce the implement which is convenient when manufacturing the plastic board. I think that there is a convenient implement except being introducing here, too.
 Plastic board cutter
The plastic board can be directly cut by this tool. Actually, this is the implement which makes the ditch to break. The tool which I am using is P-450 of the OLFA company. The tungsten is used for the blade.
Scale
The scale of the photograph is made from the stainless steel. However, it cares about nothing if being the straight line one.
Paper tape
This is the adhesion paper tape. I am using this tape for the mark when bending the plastic board. The paper tape is cheap and can be directly pasted.
The mark can be written, too.
Bending apparatus
This is the equipment to make soft by making the part which bends the plastic board hot. It depends on the thickness of the board but the 160°C temperature seems good.
The one of the photograph is the equipment which I made.
Glue
These are the glue for the plastic. The kind depends on the acrylic fiber board and the vinyl chloride.
It is convenient when using the injector for the glue when painting the glue. This is not the injector for the medical treatment. Because it lets out the liquid too much when not accustomed, it had better confirm the attitude of the liquid beforehand. It is my experience.
Tap
This is the tap to make the screw hole at the board. It is the one for the metal. If making the screw hole with this tap at the board, the nut is unnecessary. However, the screw hole breaks when strangling the screw strongly because the plastic is soft. The attention is necessary.
|
